CJC-1295 / Ipamorelin Blend Dosing Calculator & Reconstitution Guide

A common approach is to add 3 mL of bacteriostatic water to a 10 mg vial, which gives 3.333 mg/mL. Add the water slowly down the vial wall, swirl gently rather than shaking, and let the powder dissolve fully before drawing.

At 3.333 mg/mL, 200 mcg equals 0.06 mL, which is 6 units on a U-100 insulin syringe.

Community and anecdotal reports commonly cite 200 to 300 mcg. These are figures people report, not a recommendation from Keel. This blend pairs CJC-1295 without DAC (a GHRH analog) with ipamorelin (a ghrelin receptor agonist) to stimulate growth hormone release through two complementary pathways. The combined dose is typically expressed in total micrograms drawn per injection.

A U-100 insulin syringe is standard. A 0.3 mL (30-unit) syringe gives the most precise measurement for small draws, while a 0.5 mL or 1 mL syringe is better when the draw exceeds 30 units. Keel warns you when a dose is larger than the syringe you select.

Divide your dose in micrograms by the concentration in micrograms per millilitre to get the volume in millilitres, then multiply by 100 for units on a U-100 syringe. The Keel calculator does this for you and shows the draw on a to-scale syringe.

Reconstituted peptides are generally kept refrigerated and protected from light, with the unmixed powder stored cooler still. Follow the guidance from your supplier or a licensed healthcare professional for the specific compound.

Either use a larger insulin syringe or reconstitute with more bacteriostatic water to lower the concentration, which increases the volume per dose so it fits. Keel flags an over-draw and you can adjust the inputs until the draw fits.

No. The right draw depends on your vial size, how much bacteriostatic water you add, and your target dose. Always recalculate when any of those change, and consult a licensed healthcare professional.